Assembly guide — single shelter

• Open the box gently: the cover is often on top, don’t cut it.
• Check the parts against the list and sort bolts B1, B2 and wing nuts W1.
• Lay out each arch’s parts: 5 arches. Keep the four 2-hole corners (EA) for the 2 end arches.

💡 A narrow end always goes into a wide end.

Parts : Per arch: AC ×1, SA ×2, R ×1, B1 ×2, W1 ×2

• Fit a corner SA on each side of the centre AC.
• Lay the brace R from joint to joint and bolt each joint (B1 + W1).

💡 Wing nuts always face the inside of the shelter, so they don’t rub the cover.

Parts : Per arch: AC ×1, EA ×2, R ×1, BF ×1, BM ×1, B1 ×4, W1 ×4

• Same as step 2, with the 2-hole corners EA.
• Fit the male door rail BM into the female BF, then fasten the rail to the 2 corners EA.

Parts : SR ×9, FS ×3, B2 ×15, W1 ×15

• Pick the front: the side the car drives in. Parts FS, L2 and DIA go on that side.
• Stand the arches in a row: one end, the 3 standard, the other end.
• Join them with 3 lines of spacers (the ridge and both sides of the roof): 3 SR then 1 FS at the front.

👥 2 peopleParts : L1 ×4, L2 ×1, DIA ×1, SR ×3, FS ×1, B1 ×1, B2 ×5, W1 ×6

• With two people, lift one side of the roof and fit the legs into the corners: corners first (L2 at the front), then the middle.
• Join the leg feet with 3 SR + 1 FS at the front.
• Fit the diagonal at the front: top in L2’s upper hole, bottom on the next leg’s bolt.

💡 Paver protectors: one under each leg. Tap gently, the rubber can crack.

• Logo and windows go at the front. Unroll the cover over the frame from the side still on the ground.
• Cut 2 pieces of rope about 25 ft long (front and back). Thread them through every grommet of the arch, around the tube.

👥 2 peopleParts : Same as side 1

• With two people, lift the other side: the cover comes with it.
• Legs, foot spacers and the diagonal at the front, as in step 5.

• Pull the rope at each grommet until the cover is tight.
• Inside, tie the cover around each arch. At the bottom, lace the rest of the rope through each grommet and around the foot spacer.

👥 2 people

• With two people, set the shelter in place, for example in front of the garage door.
• Measure both diagonals in an X (A to D, then B to C): equal means square. If not, gently push a corner and measure again.
• Check that every wing nut is tight.

Parts : PO ×2, DH ×12, S ×12, AE ×12 (6 of each per door)

• Shiny side out. Hook rings DH into the door’s top grommets, then onto the rail.
• An elastic tie AE in each edge grommet, closed onto an S-hook.

💡 To keep a door open: roll it up and tie it.

Parts : U ×4, CU ×8

• One U anchor over the foot spacer near each corner.
• On soil or grass: 2 nails per anchor. On pavers or concrete nails won’t hold: you need a permanent anchor.

💡 An unanchored shelter can blow away or collapse. Anchor it before using it.